IGNITION ADVANCERS / REV LIMITERS / SHIFT LIGHTS

DYNA TWO-STAGE REV LIMITER

The Dyna DRL-400 Two Stage Rev Limiter has been specifically designed to maximize launch performance and over rev protection in drag racing. The DRL-400 allows a precisely controlled launch rpm limit to be set, while also guaranteeing against over-rev damage due to missed shifts or drive train breakage. Selection between the launch limit and the upper over rev limit is usually made through the use of a clutch lever switch. Both rpm limits are adjusted via two knobs on the DRL-400.

The DRL-400 constantly monitors engine rpm with great precision and randomly deletes ignition pulses to hold the engine at the desired rpm. The DRL-400 can hold a 270 horsepower engine to a steady launch rpm with less then +/- 50 rpm waver. Other launch limiters typically make the engine rpm waver through a pounding 700 rpm oscillation. This can be very hard on expensive engine components.

The DRL-400 features:
·Accurate launch limiting with 32 different settings.
·Smooth, non-destructive launch limiting.
·Adjustable high limit between 16 different settings

ZX10,ZX12,ZX14 require the ARC2 ignition in order to use DRL-400

$200.02 -

AN IMPORTANT WORD ABOUT REV LIMITERS
If your motorcycle is equipped with a factory pre-set rev limiter in the ignition box, these limiters will not extend your upper rpm limit. If you set one of these limiters above the factory rev limiter, the factory limiter will still limit. To raise factory limit, see Dyna 2000

DYNA Single-Stage REV LIMITER

Over reving due to missed shifts is a common cause of engine failure. Dyna Rev Limiters effectively prevent your engines rpm from exceeding a predetermined rev limit that is totally user adjustable. At or above the selected rpm, any further spark is suppressed until rpm falls below that level. The limiting action of the DRL-300 is very smooth and precise. Don't blow your valuable investment, install a Dyna Rev Limiter.

DRL-300 features:
·Continously adjustable from 6000, to 12,000 rpm.
·Helps prevent engine failure.
·Pre-wired and easy to install.

$118.68 -


DYNA SHIFT MINDER and SHIFT LIGHT

The Dyna shift light features a machined billet aluminum housing and is designed to withstand the vibration on a motorcycle. It is the most popular among racers. The RPM is set using the Dyna Shift Minder control box included in the system.The Dyna Shift Minder control module has been designed with extremely accurate circuitry to insure triggering accuracy to better than ± 1/2%. The Shift Minder control module is adjustable to switch at any of 64 different rpm settings with 125 rpm increments between settings. The Shift Minder is self contained and requires no additional parts for shift point selection.
Shift Minder Systems listed below include shift light and shift Minder.

DSMS-4 Shift minder and shift light - 4 cylinder 6,000-13,875 RPM - $180.93

DSM-4 Shift minder only - 4 cylinder 6,000-13,875 RPM - $118.68

DSMS-2H Shift minder and shift light - 4 cylinder 8,000-15,.875 RPM -$118.68

DSM-2H Shift minder only - 4 cylinder 8,000-18,875 RPM - $118.68

ZX1000R, ZX12R, ZX14R use DSM-2H or DSMS-2H